the PC is where you go there is very awkward with a cable. So far so good.
So because of the reviews and decided not zuletzte because of the good price for this product.
The starting point is a 20Mbit line.
Infected, "a truly hands" cable and that's it. Initially works. In the enclosed software to which the Manual unfortunately almost nothing will bear, was a maximum speed of 17MBit displayed. Real were then. In about 6 to 8, ie 1 / 3rd
That was the first annoyance.
So why come to so little? Now, after several outlets have been tried, it became clear: one should the circumstances (the wiring structures) know well in his house / his Wohung. I know, because I myself have wired my house, to standards as well as with e-acceptance.
One must make sure that not too many nips between the two adapters are. The fewer, the better.
Luckily a can was near, in the good 6 clamps were less in between, and already had the maximum speed at the maximum 20Mbit. The software was then at 100 to 120mbit.
Then came, in addition to the lack of detailed description in which you quietly on something could point out the next scandal: every 15 to 30 min connection breakdowns, complete, for up to 5 minutes.
On the two plugs twinkled merrily all the lights on, the Network Diagnostics also did not yield any solutions.
I was already on the verge of the Klumpert to send back when a friend remarked in TeamSpeak:
"So you're flying out the TS rare when you have the failures?"
To put it briefly: I had when I had no active connection open, which would permanently pinged.
1 1/2 days I've now tested by, with and without TeamSpeak:
With TS: everything runs stable at max speed
without TS: every 15 min disconnections
Solution: he wrote me a .bat file that is linked to the Task Scheduler, which is started each time you boot in the background, the pinging my own Rooter every second. So I always have a few bytes per second, which are transported back and forth, thus maintains the connection.
A firmware update has, unfortunately, changed to this fact that something is needed nothing.
Guilt is my opinion that hung **** Eco-mode, which is unfortunately not disable MTI software. This damn stupid Mode activates when no permanent flow data, by itself, and turns off.
For Hugo, something of unnecessary!
That's why 3 stars, and they are very well rated.
Had I not by chance a good computer scientists with expertise and very creative ideas at hand, this product had been valued by an asterisk and returned to the manufacturer.
If someone has the same problem, here is the content of the .bat file, you can also tinker confidently itself. Simple content in a bat file in and save and run by double-clicking:
ping -t 192.168.1.1
The IP address is usually your Rooter in your network. If you are not sure, "run" just at Start "cmd", and then your ip and the ip of rooters the command "ipconfig", then appears. this should be another, then of course use your rooter IP.
I hope this helps one or the other to the next!
Prost.