A good shell, protecting the most compact front but average quality

I bought this shell there is 4 weeks and I use it for delivery, so there may almost 3 weeks.
Already it is one of the few cases for iPhone 3G (S) which is compact and which opens laterally (hard plastic coating and the rear also serves to hold the phone with one aspect cadrillé pretty good) and a front flap semi rigid leather imitation craquelet appearance. The flap held by a magnet system positioned on the side in the rigid back shell just draw a small metal plate on the non hinge side of the front flap.

... All that is enticing, but the product quality is low. Well almost all iPhone cases are of low quality so let's say that compared to the other is about average.

Well after 3 weeks of use here is the points ...

Positives:
- Opens laterally
- Compact, only "magnifies" the phone too (not gene in the pocket of output, even denim)
- Uncommon Hull
- No gene as possible during use of headphones, lock button, USB cable (the hull stops at the corners, protecting the falls without disturbing)

Negatives:
- Opens side ... yes it is also negative because to win on appeal must finish completely fold the front which take a few seconds to clinch therefore not practical.
- Poor quality imitation leather, in barely three weeks seams near the hinge were defeats to damage little by little
- Poor quality plastic, the plastic has broken all alone next to the magnet rear side, so that the magnet fell, I corrected a shot superglue ca ...
- Hole speaker on the front steps to the speaker of the phone (even if it did not occur to me had the idea to call closed shell ...)
- The adhesive is visible between the imitation leather and plastic shell part.

In short: a medium quality Chinese hull, with its advantages and disadvantages, personally I had 4 different shells and it's one I found Best Quality ... the least worst.