Absolute satisfaction of the needs of my Raspberry Pi 2!

Well, what can you write about this Set .... The Raspi fits very well into the transparent housing, is very well secured with the supplied screws. Even the matching screwdriver was the set. The accompanying rubber feet to be named shortly. 3 attached heatsink I have not yet installed, but I'll make up for this soon. Why, however, accompanied by 3 of this body, I can not explain, because there on the top are to be equipped "only" 2 chips. On the bottom is shown still chip surface which has the dimensions to be able to receive a heat sink, however, the distance to the housing base would be too low. Thus I shall therefore can block only 2 of 3 heatsink. The power supply seems his work also neat to do, because the Raspi despite infected USB extensions (keyboard dongle and wireless) starts properly and no "funny" white corners in this first color square has. Sorry for this description, but I am, as far as the Raspberry Pi, an absolute beginner and have to deal with the matter only a little. My Raspi 2 currently runs very stable and thus I will me anytime again set this set at an extension of Raspberryfuhrparks. Apparently also possible extensions of Raspis was considered when the case because more recesses are present. Even the Raspi is good to use in spite of the housing, so fit both the HDMI connector, and the power supply without any problems at this brilliant single board. Access to the SD card is still possible as readily.

So in short, a purchase that I would make again at any time and will also in a further increase in the number of working at home Raspis.