Anyone who wants to process Molex Crimpcontakte need the right tool. After a long research on the net had the PA-21 and PA-09 (same tong, only for smaller contact types) collected the most points. Sure, you an original pro pliers for over 200 and still get a lot more euros, but for the craft table in the basement or the bench may these pliers is sufficient completely. There are cheaper, much cheaper, but they are so bad made, so that makes more damage than one can be fond in the long run. The contacts thus produced with original Molex components look as Molex wanted. They are tensile strength (you should not overdo it ... here) and electrically sublime of all doubt. Very positively surprised even the very short delivery time from Japan - ordered on Sunday, on the following Saturday, the forceps was here - well packed, by registered mail, with a brief illustrated instructions that are part of the package - which one should keep. For each laboratory and crafts table, are processed at the Molex contacts with a commitment to quality, the right thing. No negative points because there is nothing to criticize.