After reading the hat should be aware that there is no miracle glue on here. Such pads are always a balancing act between "bonding strength" and "removability" it is not possible to get both, so you should be aware in advance do exactly what you want.
So stick to the actual Rezesion the pads wonderfully on all uneven surfaces and keep them there and also my drawings (vornämlich on the wall [cleaning]).
Is as described on the package take one for A5 1 Tack, A4 2 Tack's and A3 for 4 Tacks.
This works so far also wonderful with one exception a A2 drawing men's like Tacks have such a large area, the problem that as the draft when you open the door moves underneath the paper and so it naturally raises possible attach criminal then should pass through it nothing. She now depends for more than 3 weeks at the wall again without men's fall
Due to the negative Rezesionen also the important clue for how to deal with such an adhesive pad.
Not bring his fat Bratzen to the adhesive and also not to be bonded place the pads a few seconds under pressure against the wall pressing 5sec (usually) adhesive surfaces clean where possible eg the cabinet etc. in heavy stuff: (shorthand for lazy. not just a piece of paper are quiet times more than 2 pads take when nothing helps more)
The adhesive surfaces always clean just keep at such a small part of every millimeter counts, and the fingers on the adhesive pad will cost the adhesive power adhesive surfaces are not without reason to keep fat free.
So either pull gently with your fingernail, or abziehn the slide from the pads and directly pull out the map on the pads and with the card so that the pads only garkein contact with the fingers comes.
As I said contact with oily skin (skin which simply has ansich) is fatal to such a scrap of glue.
Sounds awkward one must also not make, but if a postcards troz sufficient Pads fall quite a point about which one should be concerned. Whether it is the dusty wallpaper on the pads do not stick or greasy fingerprint on the map or the pads.
For large poster etc. you should quietly take more pads take if there is the case of a larger area, of course, a lot of power that comes to the little glue, and if you already have 200 pads should be as quiet a draft under the poster draws 2 more ,
In order to get straight to the next item just because it says adheres to smooth surfaces does not mean that it adheres to any smooth surface. Especially "extremely" smooth surfaces are not just good for glue, even not if you want to attach a way or already wiederspenstiges rolled poster on a flat enclosure door. This leads a rolled again to another point poster that should one of the minds areas take such a futzl adhesive is happening with something heavier than a piece of paper So just one or two more pads.
And please do not forget what we have learned since childhood press! Kleber takes the pressure to spread and to enter the small surface irregularities and the few seconds he needs because it reacts with the air. As a result, if you do not press it has no optimal adhesive performance.
If we add all grossly observed can one something like falling maps, photos and posters not pass through it and if they do it does something tremendously wrong or there is force majeure in play.
