They are not as rough as some other matte film, "grisseln" but also by the display hardly. In other films has me really disturbed Despite the pleasant feel of the rough surface is maintained, though not sooo rough. For this, the films are somewhat softer and more scratch-prone than the very rough copies. But for me, still a super compromise.
One often reads that there seems to be problems when mounting the film. The bubbles I can give the following advice (was professionally a lot of experience with film bonding make). Dust-free environment or at least painstakingly purified display are logically the A and O. Some say one should after showering in the bathroom raise, which makes sense in principle, but so far I have always also get it at the desk dust and bubble free adhesion:
1) For this wipe several times, slightly above the display with the anti-static cloth and then pick up the last specks of dust to the tape. Especially with the adhesive strip should be very thoroughly. Every little speck of dust can then cause an ugly bubble.
2) Look first, as the film must be on display and impressed you the correct alignment. Raises the film slightly at the top edge from, where the cut-outs for camera, etc., and strike the support material to the sheet to the other edge. Now creates the exposed splice at the display edge. But let The base substrate continue to your film, except on the upper edge of the you wear. Look again whether the so get there in about. Although you can correct it later, but that's not always easy.
3) If you are sure the orientation, the film with a finger hold on to the top and presses it already easily the screen (where the adhesive surface is exposed). Attracts now in one fluid motion, the support material under the foil away. Here, the film comes easily on the display, but does not stick to fixed yet. Anyone who is very sure that he does not have dirt under it, can press immediately when pulling the film already. These peel and press the carrier material only piecemeal. Point 4) can then also be difficult under certain circumstances, but usually goes without problems.
4) Look before, if not somewhere have placed under the foil small dust particles. You will receive the film still from very light. Is always the shortest path from the screen edge to the dust grain. With slightly damp fingers (spit: P) can scrape carefully their small dust grains. But this case really use the nails and not the fingertips. The grease and acids on your fingertips can go permanently to the adhesive. But you of course should not insalivate half Displayfolie)
5) Pressing the center starting with the squeegee, all the bubbles to the edges. Here you let the upper protective layer still on the slide (ie the quasi protects the foil top). You can here also quiet little pressure on the screen give understands via the flexible blade of course! For any damage caused by gross motor skills everyone is responsible: P. Thinking of the Dr. Best Flex System).
6) If all major air bubbles are out, it may be that there are even smaller at the edges. These are not tragic and often disappear on their own (sets times the thumb and hold the appropriate place, the heat may help that the film creates). Your now pulls the protector of your screen protector from (For the Nerds: yo dawg, i heard you like display protection, so we put protection on your display protection). But keep doing immediately the actual screen protector gently fixed once their they can grab. It runs like this again a little high, which can be annoying. Be cautious of this. It has proven itself quite smooth peel the foil (180 ° angle). In a 90 ° angle (perpendicular to the screen) it draws most likely the film again. And did I mention that you have to hold the film)?
If you follow these steps so you should actually be able to achieve a perfect result. Thinks that, one can always go next time a film. I versemmel certainly one of 5 films, but sometimes everything works immediately. But the end result can be always seen. I nurze also the "big brother" for my Nexus 7 and I'm just happy with it!
Conclusion: strong buy recommendation for all those very rough films too sprinkle the display, but clear films may not, because they feel so "greasy" and so strong "vertatschen" (fingerprints for high German speakers)