slight adhesive residue on the plastic holder
sharp edges in the area of control buttons and the display front
The Klebereste unfortunately I could not remove. But they were not so present, so for me acceptable.
The sharp edges I found that annoying and even somewhat dangerous. Especially in the area of the display, I found it very disturbing when calling already. So I removed the sharp edges with a fingernail file. The look and feel make up for that little labor.
The mounting of the shell provides for me in the long run seen, however, a risk. On the one hand the plastic intake sits on the edge of the silver mobile phones and these creaks even at slight pressure. This suggests forward that could be damaged sooner or later the silver edge. Furthermore, I am a little skeptical of what will happen when a few grains of sand, etc. Bumble between the phone back and the plastic receptacle.
After only one week plan with me a plastic receptacle. The crack was located on the lower side thus went the shell back. Since this is probably unfortunately not an isolated case as can be seen from the reviews (sometimes compare the different colors), I must continue to look for a suitable envelope.
Conclusion:
The shell I would like to keep - with the deficiencies and concerns. But the crack in the plastic receptacle is not acceptable for me. If you're lucky and get no crack, herewith certainly has its joy.
Optics / haptics: 5 of 5
Protection: 3 of 5
Quality: 2 of 5