It is ill-advised, poorly this support is indeed compatible with the Panasonic brand, I have a 65VT50 and everything went well.
I sought advice from the service of another specialized site, they sent me to a tilt wall mount 200, ridiculous!
So I started following a positive response from another commentator Amazon here.
The installation itself is simple, a video circulating around by typing the name of the media shows you how.
The explanations are relatively clear.
I recommend as many commentators here have its own spirit level, that of Vogel is a bit light, has good use, it is not bad I thought, but better be careful, especially for install a "fixed" support.
Also, for a Placo wall, do not install with the supplied plugs, it is suicidal.
We must Moly, beware take "exactly" the same screw size, holes are tight.
Explanations say take a drill 8, what I did, knowing nothing there, and obviously for Moly, the ankle will require a diameter of 11mm !!! So I had to expand a little.
So molly bolts to buy, I've built 8 instead of 4 recommended supporting each ankle for a TV 40Kg total weight of 45kg.
Obviously, an expansion clip to put the pegs in spider In back, and then we go!
I saved 199 that would have taken my store Digital me (+ support this premium to be paid) and being handyman!
This support is really good and good quality.
It is supplied nuts to be able to adjust the gap between the wall and the TV, allowing to leave enough space to put your cables before installation and that it does not impede the retention wall.
Depending on the brand, it may be necessary to buy HDMI cables bent, but it is up to you depending on your TV model, I did not need at all!
By cons must know that it is so close to the wall that once that is established, you can not touch the power or HDMI jack on the TV (though my TV is enough well designed for that if I can do it).