Conceptually, not bad, but absolutely not reliable

Straight from the start, this is already my third different pruning saw (1x moisture damage, 1x canceled - each of Güde), so I have been allowed to gain some experience. Unfortunately, it is now my third defects. But one by one. In principle, a good device, I liked as a reason to buy the one hand the opportunity to disassemble the unit completely and thus can also saving space. In other saws depends also after cutting often all together, because the cable from the keypad is consistently up to the saw. Here, the contacts are inserted. Secondly, I also liked being able to take the saw as a normal chainsaw for small tasks. I have of course the right trees even right sawing. But the big spruce moped is applied Sometimes something exaggerated and costly.
So I also started the determination in accordance first with the thinning of trees. It is pretty far up, but it is somewhat difficult to control and because of the heaviness and more for men, since an enormous lever acts. I've been through the installation of a front retaining clip of one of the other defective equipment counteracted (not everyone has but of course are around, but could even be innately here). By connections it seems a bit unstable and clunky, but it holds and is going well. The possibility of the saw at the top to bend in two stages is also quite convenient, especially since the sheet front also has a stopper, which is also working from the bottom up, that is the top of the saw can use.
Then I came up with the idea, they want to use the chainsaw solo, small stems that standing around without crown in the area, 10-15cm in diameter (young maple and rowan), cut at ground level, because by the circumferential strap so beautiful is possible. So nothing earth - one thinks. Perfect handling, as small and light as can keep no "Large".
Unfortunately, the saw here has given up the ghost after the third stems, the engine breaks through what is clearly accompanied with interesting lighting effects through the housing and is also hard to miss at idle on the basis of decreasing and stuttering speed. So that's it. Was supposed to be not impossible task for the 900W motor, nothing else is so like a firmer road.
So it's only 900W power consumption and half the engine output? The chain was definitely hot, is it still.
Conclusion: practical concept, as anpruchsvolles Pruning handling - but unfortunately only for the very, very small tasks.