The crimp tool has no recess for the connector tabs that hold later with Boot with homemade connectors, so you can during crimping not quite push the plug and during crimping so the contact plates are pressed wrong. Instead of 2 points of contact you have a best or not, also the plug no longer conforms to the standard and stuck in the bushes. For connectors without plugs noses you have no relief, because these are intended for casting. For DIY with Zugentlastungssteckern therefore completely useless. Obviously you have to spend on a proper crimping tool but more money.
By contrast, the Stripper works top notch and the cable tester also, the punching tool I have not tested.
So 2 stars, out of disappointment over a foreseeable mistake or customer deception.
LogiLink network tool set with bag
