In the product description, "The interior is variable divisible means 2er vertical Velcro inserts with ears" and "Fujifilm Finepix X-S1 (HS20 HS30 HS33 see customer reviews from 10.02.2012)".
In fact, the interior can be adjusted, but only in width and not in height. An important point is missing namely in the description. The separators are not square, but trapezoidal. Thus, one can not raise or lower the set separator. Only in width are adjustable.
But I need this exact height adjustment for the Fujifilm Finepix HS30EXR. According to data and user review that would fit, but I wonder because real as they can go. The separator of the bag are simply so high that the surface mounted camera then is greater than the available interior space. Well, you get the lid on, but you have very pressing and the "mesh pocket in the lid" is definitely not to be used, because the presses completely on the display. Go down the lens, however, has yet about 3-4cm air. This space I would like to use, but no height adjustment is not possible.
Because the called "ears" to the Velcro inserts. These are nice, but reinforce my problem even more. The Velcro application itself is so wide that it fits between the lens and grip the camera. Through the "ear" but results in a double-wide and will not fit definitely. So the whole camera grip is on the use and the camera is thus about 2 cm from the bag up and out. Well, you can press the camera purely something, it goes a little deeper, but that's not the whole point. In addition, then is still the limit through the use of height.
One solution would be the use of bottom easy to bend a little and thus get lower, but this is not possible due to the trapezoidal production. It therefore remains for me really only one solution: The separator must all get a result but you lose the storage space on the side and at the same time the objective is always then at the bottom of the bag.
The "water, sand and dirt repellent rain cape" I could not test so far and would like it to be honest either. It includes only the front, top, bottom and sides, behind the bag is open. I would not really try with proper rain. Why is an opening because not below (you wear the bag but upright and not lying)? Or the greater Cape and closes completely?
"Attention, revised model from 08.03.2011 with now 19cm height Inner dimensions: W / D / H: 16x 12.5x 19cm Warranty 5 years !!"
Would have been nice if you knew what mass had the model before it, to which so many ratings relate. My model here has inside at least not 19cm. Directly from the floor to the upper back wall there are known 17cm. Through the internal network and the pressing inward raincape then go about 1.5cm lost. Effectively used, so that the power is directly on the display (not suppressed) are therefore only 15.5cm -> and this is for my Fujifilm Finepix HS30EXR unfortunately too little. The width of 12.5cm true, but it is also just at the top. Down there is Änger. At the bottom there are only 9cm, so to put too little to the camera.