* Knob for temperature setting available
- Knob for temperature setting values without labeling and without display
== == Irons
- Piston is hard-wired with station
- The soldering iron too rigid cable (moving the flask slightly more you move slightly the whole station)
- No indicator whether the piston / still hot enough to heat, or even heat is already (for the latter you can also just hold your hand in the vicinity)
- Smell when first used rather suspiciously melting Kusntstoff
- Plastic handle is close to the tip rather warm (if you DESN handle quite normal centered holding no problem).
== == Desoldering Punpe
I thought they absolutely need, but requires probably more practice, I was too clumsy. But had the impression that for a successful sucking the tip of Punpe would be much smaller. In my opinion, can thus be sucked just a huge Zinnklumpen or a through hole from the back side of a board. In all other situations, more than the air is "pumped" around the tin.
== == Replacement tips
+ Are several available (you've never been used)
- Could still contain a slightly smaller tip
== == Helping Hand
+ Fulfills its purpose (stiffness of joints can adjust anyway with pliers)
Lot == / == tin
+ Fulfills its purpose, successful work: IEC socket on board of TFT, cable in a microphone, IR diode on board a remote control, stiffening of the cable strands for screwing in a distributor
All in all, work station & piston bit cheap, but are absolutely funktoinstüchtig and unbeatable. For beginners and hobbyists to the part probably more than 3 times a year infect ideal.