Hello, I received a free sample of this pocket and proceeded to test it for several days. In terms of packaging, it comes in a small cardboard box. At the opening of the latter, there are the shell in a small plastic bag and a small installation manual. The hull is in two parts: a hard plastic front light gray equipped with an integrated plastic screen protector. The rear face on it is kind of soft plastic "rubber" clear and charcoal gray two-tone gray. A hole is present to access the lock button but do not have too big fingers because it's close enough and far enough button. The power and volume buttons are very responsive. Very good point because it is not always the case on "high protection" shells. The screen protector is perforated at the home button to allow the use of touchID. It is also pierced at the earpiece, the front camera and light sensor. Installation is really simple, just to accommodate the iPhone in the front section, then this set in the back. The rear panel fits perfectly the front and comes even include a small millimeter. The set is really supportive. If dropped, I think the two parties do not désolidariserons! To be honest, I have not tried to do this test with "my precious" ;-) That said, I give my hand to cut the 2 parts remain assemblies. It is really obvious. The iPhone takes about 8 mm in width and same height and about 5mm thick. Felt when one has the iPhone in hand but it is inevitable to have sufficient protection in case of fall. At the back of the shell is quite slippery, I would have liked a rear that hangs a little more. In fact, one-handed, it slips a little. After several days of use, at the touch, I see that the screen responds perfectly. It does not catch. We do not feel that there is a protective film. For fingerprints, that's unprotected: no more trace, not less. The hit of the shell is not unpleasant. It's still a lot, but less "sweet" that my Apple leather shell. No fingerprints on the rear of the hull against. I took 2 times to go running iPhone, the iPhone in the pocket, no condensation on the screen. The caps at the audio and lighting taken have not moved. The iPhone was really well protected. In short, almost flawless. The only flaws: back a bit slippery and lock button a bit difficult to access. At that price, I can only recommend this protection if dropped should really protect the iPhone. I made a small visible video on Youtube ... just looking "Testing ANKER Case for iPhone 6 and the iPhone 6 Plus"