Regulators were monitert with the supplied adapter (RA) to Danfoss radiator valves. As a craft rather untalented man I have ultimately hammer out unaided. It costs a bit more force than expected, the adapter should get so that the regulator stuck, but after 3 controller, we went reasonably and you know to what you had to pay.
The controller is properly seated in the correct assembly. You have to when using the Danfoss adapter but really make sure that the adapter is really screwed up the back to the valve seat and there already tweaks you've once the finger.
By the time you then actuates the first adjustment run the controller and then the error F2 receives (adjustment path too long), it is known that the ring is not in the back. In this case, I do not advise to any coin zuklemmen therebetween as one sometimes reads, but again starting over.
During assembly, all is pretty hot - because the valves are quite open - so you should have trained and prepared prior to the actual installation, the thermostats. After installation, I then only times all set to "OFF" to check that the valves are also really closed.
The actuators of control are quite audible - but I can not imagine that you can improve a lot here to me. Otherwise, the controls are easy to read, the light of the Display for the settings is very pleasant and the numbers also large and easy to read.
The controls are quite a bit larger than mechanical control. That depends on the product images is not really out.
The battery compartment is located opposite the display and you can slide it easily with a bit of pressure to the rear. One can also batery in the mounted state change easily or to perform a reset easily removed, in which one simply pushes the cover backwards. In Neueinlegen the batteries should only be noticed how the polarity was - because the view is restricted in the mounted state.
As long as one operates the Regeler alone and not controlled by a wall thermostat - you can set an offset. This will be done as a rule, because the measured temperature in radiator close matches seldom with the room temperature (unless the heater is made of;)). While this is already taken into account by the manufacturer, because the measured temperature on the thermostat (according maxbuddy software.) Is about 2 ° higher than the set point is the set - but is the possibility that adapt well to the individual space conditions from my eyes indispensable.
I have reviewed all the experience with the system as a complete home solution under the Max! Cube, therefore, only the review of the radiator thermostats alone.
Therefore, the radiator thermostat gets 4 stars - even if the complete system only gets 3 stars, because of weaknesses in the software and the wall thermostat.