Fast delivery, great service, after several attempts, I then but the film as far as getting in a good mood. I can only connect the 5-star review of a pre-reviewer: For the first order I was not so excited about the product, found on the vendor - the company -angerufen HandyNow in Essen, then me again 2 films were sent. The company could be reached immediately, the employee was very nice and the replacement sheets already 2 days later with me. The installation problem is likely to be the same for films for the size of the MS Surface RT with all other providers, maybe even bigger. The film is absolutely properly matching that at z. B. Diverting from the top of the screen by half a mm exactly this half mm then at the bottom overlaps thus assemble very carefully !!! The film is well received and, above all, almost bubble-free: However, I have for the bubble-free several times, the film will have to raise a little to get the dust off below. If even a small dust particles under the film, a bubble forms around to this. The tip with the adhesive film and the words' not with your fingers on the rear handle "is very good. If you follow the tips and applied a lot of patience, you will be rewarded with a good result. Patience is needed also because you get the feeling that at any time you at a corner again raises a piece of foil, after more dust draws underneath. But with the adhesive film (slightly against the adhesive area, so hit the underside of the film in order to remove from there the dust particles are usually the particles on the film and not on the glass surface of the screen) to get it out pretty well. After half an hour of work I have only in the border area had small bubbles, do not interfere further. As has led a pre-Reviewer: Prerequisite or preparation for the application of the film: 1) Hold the film short to the heater so that it discharges slightly and dust no longer attracts. 2) The film in the bathroom install, after having the humidity increases by warm water. (Thus, less dust flies through the air) 3) Be sure to also assemble videos that are referred to in the application instructions, view previously. Use 4) microfiber cloth and a (old) Plastic check or phone card for installation.
From the visual impression, the film does not stand out in wiping motions with the fingers I have a little duller, slightly braking feeling, which is not surprising, since you no longer now, with your fingers directly on the glass plate of the screen, but on plastic Now the time just is not so smooth, wipes. In addition, the operation with the stylus feels no longer beautiful liquid because the pen tip for the same reason - easily adhere to the film. But I have a protection against scratches for such an expensive device. Only once have scratches on the glass of the screen, you have held the slight loss of comfort in the operation now (greater) loss of comfort in seeing and a loss in value at a possible resale of the Tablet PC in the future.
