The film is very dusty from the packaging. The included table-cloth has a smooth and a rougher side. The rough side fluff unfortunately itself and is good therefore only partly for the envisaged purpose, the small spatula is okay. The FoliX film is a total of only 2 layers, consists only of the carrier film and the actual protector. This looks very stiff, compared to other films. In Vikuiti z. B. the whole thing is set up 3-ply, attached the straps of the carrier and cover films on 2 sides. This facilitates the application.
However, the absolute scandal of FoliX is the fit. An initial visual inspection of the film held on the phone, already shows deviations. The outer 2 of 3 holes for the control keys are positioned too close to the middle. This gives only the middle button a clean circumferential contour with the film cutting edge. The other two holes are very unsightly above the keys. The cutout for the speaker above the SAMSUNG lettering is also positioned wrong in the film. He is too high (if you want to fit the cutouts for the buttons) and also too small, so that the speaker grille does not fit through the cut.
To finally take advantage of the Wave I have the speaker cutout enlarged with a scalpel and have them placed. 2 small bubbles remain. Visually, the material may seem to have good properties. Generally it is too stiff and too thick, and it remains at the entire circumferential edge hanging fast. Perhaps there would be less 2 tenths better throughout the outline.
According to instructions should you start up. In so doing, first does not fit the speaker location, down on the keys then nothing at all. To me, the film gives the impression as if it were bad lasered or seller has labeled a similar film on the Wave 525. For 3.99 it's just annoying to get something offered. Can only strongly advise against this film, they use now as a transitional solution and get you quickly to another.