So: Let's start with the fact that you do not know which of the two lamps which side belongs. In my Q5 it is so that the front cord runs towards hinge and just as well as the exchange of light will be installed, could not otherwise snap. You can not just turn the. Back on the other hand, it is exactly the other way around. The two lamps of KingCK are equal but only at first glance. On closer inspection you can see that the replaceable projection screen to be inserted with two lamps on two different sides. But you can not tell which is for the left and right side. You have to find out by trial and error yourself. Luckily I had bought two packs, ie for all four doors, so I had each variant twice and was on the safe side.
So easy to install, however, still not. Well, take out the complete Bauteilaus the door trim is actually easy thanks to the supplied Utensils. You put it on the one end, where you guessed that there is the clamp, a, turns slightly and lifts and you clicked the old lamp from its position. But then the surprise: figure out the black connector with the cables from the coupling is a true Pfriemelei and I was glad that I had two of these small tools, because you have to lift the two tabs at the same time and the one creates hardly with bare hands since one not easily underneath comes with your fingernail.
Then the relief: After all, in this plug is all obvious. By a flattening on one side you can not insert the plug incorrectly. And immediately lit the lamp. Then you can control the direction in which shines the light image and decide if it's right around. Then plug it back into the hole in the door trim and finish. If you have done it at one and got it going very fast at the other three doors. All in all I would say you need a maximum of ten minutes.
The result, however, delighted. In daylight, you can indeed see nothing at all of the lighting, but when it's dark, it really looks great. And the little frustration with the installation you forget so soon. Still, I prefer so from a star. This is done not really customer friendly. On top of that with me - how loud reviews with other customers - four completely pointless additional projection slices are: two are exactly the same as the built-in with the normal Audi logo and two with the RS logo. RS I did not. Schön would be a S-Line logo, after all, this series is much more common. And there is still another Audi logo with the ring around it that would have been a nice bonus, but so? Utter nonsense.