Even a pair of information previously:
-The Original metal shaft that is always with radios this is no longer needed because the radio is screwed to the cheeks, which are previously plugged into the drive bay. (Screws not included! With my JVC radio were what with supplied)
-In Most (or all?) Double din radio is at the front nor a narrow plastic frame which is clipped after the installation of the radio included. This is also not required.
So now, but for the evaluation:
+ The color is consistent super, could also be an original panel.
+ The gaps voices also super.
+ Radio sits not super and wobble.
+ Radio adapts to rework the design in the super double din opening of the diaphragm.
And since we are also the negative reached:
Bite the whole thing fit well I still had to do the following:
Expand -The screw holes on the plastic jaws to the rear otherwise the radio has too far out looked forward so that the panel could not be more "plugged". (Preferably with a Dremel or if not to hand Cordless Screwdriver)
-The Holes in the mounting frame I had a bit extend so that the plastic pins of the panel have reingepasst with a screwdriver (cross).
But who is such an installation trusts for which the above-mentioned steps should pose no problem.
All in all I'm very happy and I would buy the aperture in there again
