I was like many others looking for a good alternative to a pneumatic impact wrench. After much research I came across this property. Important was mainly a halfway decent torque, as many favorable impact wrench only provide a torque of about 200 to 250 Nm. My car is a Mercedes from the W124 series, often praised for their durability and sturdy construction. For me, the revision of the rear axle was at. 21er and 22er bolts are installed and as some of the ravages of time has gnawed at you. Therefore goes here without impact wrench nothing. The alternative would be a tube of at least 1.50 m length -. To be balanced to the required torque on the screw and a strong farmer's breakfast - renewing or ratchet wrench. It makes life, however simple and easy to use Impact Wrench offered to the loszurütteln the brown plague. The only drawback of the impact wrench sets immediately to full torque going on, the key for countering one should if possible hold on tight otherwise the flies away in a high arc. A dosage as in Druckluftpendant is not possible. Quite on the nuts were not, but with remaining 2 cm Thread not to loosen the nuts I can live.
I was skeptical whether the quality, because normally I only use tools from Stahlwille, Gedore, Hazet and co. but the unit has done super. The impact wrench has become more suitable for hot in some screws in the action but it did the job wholeheartedly.
Conclusion: For the price can not expect miracles, price - performance goes but definitely fully in order, especially if the device is only used from time to time.