As far as the part now depends on me to the wall and is serving. But there were placed unnecessary stones for the path (s partly already other reviews.): 1) The decisive fastening screws of the two to be attached to the TV rails are far too long and are only usable in full, two of the supplied spacers if one uses. 2.) However, sags slightly by the weight of TV wall mount down, must (as described earlier) two spacers are mounted above and below no one. So the YEARS. Screws must definitely be significantly reduced for the top. The specified in the manual distribution of 4 spacers on all 4 screws is incomprehensible daydreaming !! 3.) The mitgeliferten 6 dowels with 12 mm (instead of 10mm) first, too big for the corresponding screws (the tightening dowel by turning it) and also for most bad because you usually masonry drill has only up to 10 mm. NB .: Due to circular movement of the drill at the end of each hole can be here but help effectively. 4.) The holder is unverständlicher- and irritating as delivered with fully tightened hinge screws. These must first all be loosened evenly to allow easy mobility when operating later. Note .: Kirk had not below these observed when loosening hold the opposite screw. Then loosening is namely easily !!
In this respect, the manufacturer has here mostly unnecessary 'easy' missed! To all these problems / workarounds to avoid the same, it is advisable to manifest equal the TecTake TV wall bracket (only slightly more expensive, because free shipping) to order, because this has apparently slightly shorter screw and the tilting can be compensated in both directions. Note .: While you can see the Mounty-rails for the latter, conversely, assemble / insert on the holder, but by all the weight is on the weak-duty lock screws. Is not really a good idea ...