Relatively shortly after the purchase of the notebook I was not so satisfied with the keyboard. The most important buttons are very stiff, telweise no longer (Shift left) went. I had then rumgeschlagen almost a year so. Eventually I had to say as far as either a new keyboard, or a new laptop is needed. Whereupon I have been looking for a, and found this. Normally I would not have resorted to this "cheap solution", but the reviews were so good that I thought "Trying out". I was not disappointed. The change will only take about 10 minutes for an untrained wrench like me. Of course I had started only once without guidance and disassembled the laptop :-) half. It is sufficient that the rear cover (two screws) take to solve a screw which is marked with a keyboard icon, and then expand the keyboard from the front. I had been looking at Youtube for "HP Pavilion g6 keyboard replacement", the video is 2:30 minutes and the guy grabs in time even the laptop out of the package! My tip: even the small CD-Rom Loosen the screw and remove the CD-Rom, then you can very relaxed rausdrücken the old keyboard from behind. Another tip:. When the Moors the screw f the keyboard again, this on the screwdriver, hold vertically into the air and lowering the NB on top of the screw, so avoiding the risk that the screw falls into the device, at the same time the most difficult part :-) Conclusion: Great keyboard (tactile, light, speech), super simple installation. For me, better than the original.
