3 protections provided in the package .... it was not until the 3rd that I finally get to correctly install just about protection. The other 2 are parties to the trash. 1st test: unsuccessful because despite the protective layer 3 through mesh. I try takeoff: a damaged rim which does not want to stick. I take off, I clean, I turn to the 2nd attempt: unsuccessful as a speck of dust has dragged which causes a bubble that does not want to remove, the obligation to take off again ... and again on board does more stick behind. Same with the 3rd, but this time, the bubble is not in the middle of the screen but on the edge, so unobtrusive. I am generally happy with atFoliX products, but now for once, the cut is really damn bad. It would seem to me more logical to start gluing from the (flat side) to be a landmark for orientation, rather than starting from the top of X10mini pro (side with cutout for the speaker and others) . After a few hours, the use is great and well cut sun glare. By cons, protection comes off. I wait a few days just to see if it holds before ordering another protection of another brand.
EDIT: Customer Service atFoliX awesome. They contacted me after I put my rather negative opinion, to offer me a new batch of screen protectors. Mail received very quickly. It's rare to see a seller décarcasser much! Thank you to them.