If the antenna cable had been professionally soldered on the board and been secured, I would have awarded 5 stars. Until the right location for the antenna found, she had to go through (from unpacking to final position) some movements. The very rigid cable has passed the movements inside the antenna and the igendwann Melgung came: No signal. As a "rotating" grommet is unlikely suspected I equal to a cable break. Short gesgt: Open- antenna cable ends in the hand corroded wire screening demolished before the solder joints and the inner conductor is not embedded in the solder, but only launched. Since then the hot glue dab has caused no tensile or rotary-relief. I have everything set down new and soldered, and a larger set Heißkler- klex. For great designs Now is also a function einandfreie given. If the manufacturer does not properly strain relief for the cable want to provide implementation, is not equal to an electronic defect or an unfavorable reception conditions which cause: no signal. I would also can return the whole thing as Garatiefall but I have spared the effort and legwork.