The protection comes in an expensive package. In the black Pape is a plastic box with hinges and transparent cover, in about as you know from high-quality filters.
On the back of the board is a barcode sticker with A7 is down in a tiny font. Nothing else matters.
The part is made in China by GGS Jingang Photographic Equipment, Inside are
- Impregnated cleaning cloth paper in sealed aluminum foil labeled Screen Wipe
- The protective glass of 3M.
TIPS FOR FITTING
Procedure (you need this to have no fear, the mounting is easy and takes about 4 minutes):
1. For the time being I have to work and surroundings sucked with a vacuum cleaner and all the windows closed to avoid to train. That's the most important thing in this matter, because if lint or dust get on the screen, everything is dirty. Then maximum illumination without shadows: This is very important to position carefully and successfully to the protective plastic film. Then provide soft toilet paper to wipe around the display after cleaning
2. Clean the screen with the impregnated cleansing wipe thoroughly with a double sheet SOFT toilet paper (I took 4-ply) wipe. Drying is important to prevent plaster strips.
Repeat operation as a precaution again and check that no plaster strips are present. Turn on this check camera at all angles. Putztüchlein not throw away, but cram it in its case, it is still needed (see Figure 6).
Then vorpositionnieren protective glass: It has a small gray font GGS, which belongs above.
Now it's getting serious, so take a deep breath:
3. Remove adhesive foil with red lettering 3M Electronics at the corner with the round protruding part carefully in half, now it has to go fast but so dust has no chance.
4. start at one corner (eg bottom right) on the display, then the second corner (top right) and adapt carefully set up parallel to the edge towards the left and press lightly, this protective film pulled higher to obtain good visibility. Possibly even pull off during application completely if the visibility it requires. ,
5. If the direction is correct, complete and attach all press firmly, from left to right.
Unlike plastic films actually no bubbles come about and you do not need to draw smooth with a credit card.
6. Wipe the fingerprints with the cleaning cloth.
Alternative mounting method:
Pull Schuzfolie with red writing 3M completely, position the film with both hands, put in the middle and press the edges. Here you can touch the sticky side under any circumstances.
CONCLUSION
Anyway, I am 100% satisfied with the part. It also does not see that a protective glass is attached.
Therefore, 5 stars and buy recommendation.