I had been looking for an adhesive, with which I could stick the detached film to the door of my refrigerator again. A consultation with a specialist company revealed that it is the film likely to PE (polyethylene) handle. Polyethylene is due to the chemical and physical properties one of klebefeindlichsten plastics at all. The wettability of the Surface - a basic requirement for gluing - was very poor. For permanent and high bond strengths are therefore complicated Surface treatments necessary, but only in the industrial sector are possible. I've yet with Pattex Repair Extreme adhesive tried, have the two adhesive surfaces cleaned with sandpaper, the adhesive applied to the "timber" side of the door, pressed the film and the pressure for a long time with the help of a heavy, smooth object upright receive. Thereafter, the film was smooth glued to the door. Remains to be seen how long does the splice. Less complicated proceeded sticking a Hängels of a cup of soft-paste porcelain: re-cleaned the contact surfaces, wets the fractured surfaces of the cup with the adhesive, pressed the Hängel and aligned. After 5 minutes everything was fixed. When it comes to the instructions for use, the adhesive is waterproof. The splice should therefore also be dishwasher safe.