Scope of supply:
- 3FoliX protective films for the display (Ultra-clear and hard-coated)
- 2 black films (? For the battery cover is the Aussparunng for camera and flash is missing?)
- 1 doctor
- 1 cleaning cloth
- 3 different sized assembly instructions
Structure of the film:
The actual screen protector is provided on both sides with a protective film again.
- Slide on the "finger side" with red gridlines
- Clear, at first sight unrecognizable foil on the display page / adhesive side
Assembly:
Previously test fit of the protective film by hanging up.
The assembly is best carried out a room with high humidity (bathroom with running hot water) to bind dust and not to let on the display or the adhesive side.
Clean the display thoroughly.
Remove the clear film and apply to the display. In this application to one of the long edges so that the film is not installed wrong.
Remove the red film. There are two tabs.
Push the air bubbles to the side with the squeegee
Result:
An invisible protective film on the display. Everything is very good to see. To the naked eye no impairment is to be recognized.
The fit is 1A.
Tip:
For me it did not work out with the dust-free the first time. I have taken off the film again and rinsed under running water. Then so far shaken off, leaving only a few tiny beads of water were present. The water could be completely pushed to the doctor aside. At the edge of the water, I wiped away with a cloth, so that it could not enter the cell phone.
Needs improvement:
The assembly instructions. While it lay in three pieces in different formats, but it was not apparent that there are two to remove protectors. The film described in the manual with the device name is just not on the side that comes to the display.