First, let me say that the role holder has everything you need and even more. It works perfectly so far. In the cling film, you have to work a bit with feeling, but nothing compared to scrap, which I had previously. It is very good that after cutting remains enough rest to get him for the next time to grasp. The filling is also not a problem, even if it has already been criticized here. I think there is only one operating error. Now for my criticisms. The material is so thin (only 2 mm) that it bends in an unassembled state very easily and affects the exceptionally cheap. Here one has clearly saved in the wrong place. The sparse assembly instructions can be seen that one should it screw 4 x. There are however at only 2 screws and dowels. It is also imperative it tighten in 4 places and I strongly recommend additionally to use wide washers so that the thin material does not break. 2 points deduction, solely because of material savings. Otherwise, well thought-out concept.