The bar was sufficiently packed in foil and wrapped with plastic tape.
Immediately after unpacking the me but the reason for the one star deduction was equal to the eye.
More on that later.
The bar consists of three parts.
A lower rod, one upper bar with the slight bend and the round rod for heaven itself.
The latter is connected to the front and open with a piece of transparent hose.
The brackets (one for up and one for down) are from about 4 cm wide and 2-3 mm thick metal.
Thus the whole law is stable.
As in the picture, the mounts are designed similar to a clamp.
An assembly instruction is thereby. This is, however, not be required for craft some more experienced people.
Not everything always make for those who themselves or give you other things better it is, however, well represented and should succeed.
The "structure" was carried out within 5 minutes.
Alone, however, a little "tricky" because the holders. So best short someone to make the short what festhaelt.
After the Rock Star Baby sky was drawn over it (fits naturally top) saw the whole thing pretty good.
The stability I'm in the model here not worry.
It is used on a cot with closed headboard.
However, it can be used with bars at the top end by the holder 2 also on an "open" bed.
However, the upper and lower end itself must consist of a board. When a round bar is likely to not work.
The bar was so high it is mounted and the sky now has 10cm air to the ground.
Now to the star deduction.
The lower bar had recognized slight rust at the upper end, and the upper bar at the bottom.
The edge of the tube was not sufficiently coated. Here, perhaps, is still a need to improve.
Nevertheless, there is a clear buy recommendation for the sky bar of Roba.
Not cheap but very stable.
Whoever saves here's debt if the baby has a bump on his head.