This part looks really great. Actually too bad the housing to screw behind the TV) The only (minor) drawback: I have another case in which the half-shells behind the USB connect minimal bezel and thus fix the USB port. Plugging in USB, the pressure is transmitted to the case. Since you also have at schwehrgängigen USB sticks have no fear. By design, the USB ports are not fixed in the aluminum housing. Also worth mentioning is the notch underneath the SD memory card slot. Here you can leave the available for Pi Micro-SD adapter is always plugged in and can still change the Micro SD. A small slit is missing not to recognize the status LEDs. For the installation but not enough of the mentioned in the description of Phillips. In addition I have 2 small nuts for nuts required. For 12EUR total a super body. Until recently, the housing was, as I recall, offered even for 20+ EUR. That was me at the time but then too much.