Here is the reality:
1) 1 inch (25mm) hose plugged. Then sawing
2.) G1 screw connection for 1 inch. Thread then saw off
3.) 1 1/4 inch (32mm) hose plugged. Then unscrewing
4.) G1 1/2 screw for 1 1/2 inch
The pump itself promotes very good up to 5 m high, an indication of 6 m is an absolute limit. The immersion depth is max. 8m given, but how does it work if the head only max. 6m is? According drawing is meant above the water surface as the head height.
Pressure can not build submersible pumps, but it splashes vigorously out of the hose.
,
,
The float switch can be adjusted to, so in length and thus the runtime change and it can be easily vertically clamp for continuous operation.
Foreign objects up to 25mm to abkönnen the pump. Enormously I think, but I could not test it. But sludge from the dewatering shaft skin so they carried. Note that this course of hose must be correspondingly large.
It is advantageous that due to the relatively low power consumption, the pump can also be operated with a power generator.
Another positive: runs silent and has that is designed for heavy-duty use very long rubber cable.
The minimum suction height is approximately 40mm, then it begins to suck in air. 15mm is the height to the bottom water inlet.
,
,
Conclusion:
++ Pumping well
++ Quietly
++ Durable rubber cable
++ Acts (can you not daily) optically very well made
++ Fairly low power consumption (390W) Operation therefore also possible with power generators
++ For large quantities of water
o without Rating: ./ x x.
- Connection must be sawn
- Cables are strong chemical odor in the storage room from
