The docking station makes the extent at first glance a good impression, the included inserts for the Z3 and Z3 Compact fit properly. To make the whole thing a bit stand Safe However, I have the charger with double-sided tape stuck on the table, in my opinion has the part also be much harder because the Z3 but is very top-heavy in use, keep it, but one the whole is very shaky Matters awareness, well, nowadays everything is made of plastic and at the price I have honestly expected anything else, but now the main point of criticism: I and many others have with probability bordering on certainty a protective sheath eg (redirect = true & ref_ = oh_aui_detailpage_o08_s00) to the good part, now fits the application only for the Z3 / Compact pure, but not with envelope. Now I have long worked and sanded one of the two included inserts with NEN small Dremel and some sandpaper until it fits, otherwise I would have sent it back because it's completely impractical always to take the smartphone from the case to charge it at the station, times apart from the fact that the cases today (where we are when it comes to plastic again) the procedure to join the company in and out only a limited time ;-). This should at least think of any advance if he buys this charging station. Without cover, no problem everything was great, allowed to the sleeve but around not fit the supplied Einsätz without insert and envelope allows the Z3 in the station also charge but there is then every ne fumbling the magnetic points to meet properly and is still shakier than it is already.