The with popular inkjets printed, always something self-tinkered-looking and extreme (humidity) sensitive CDs, DVDs and Blu-Rays are not only completely waterproof, but finally come also from the look and feel of professionally printed copies of the industrial production approach. The surface receives a slightly satin finish and also summarizes like a real pressure on. The disks act in total much higher quality.
To process a lot has been already said:
Just one thin, but so that the spray runs into a smooth film, spray. Finished! After 10 minutes the surface is dry to the touch. After half an hour she makes a fully reliable impression. The liquid standing on the surface loses during drying by evaporation of the solvent significantly in volume, creating a filmy coating. The drying can be very good at a slight matter of the area will recognize.
Important!
To edit Put the discs flat, so no spray from the bottom can reach the read side. I used a scrap piece Floor PVC. That went well. Paper or fabric are probably less suitable for Ankleb-risk.
Pay attention to dust-free! Disk clean wipe / blow and avoid the spray of dust. What falls in the wet film, remains visible ugly!
... And keep stored until drying of the protective lacquer FLAT the discs so that no runner bzw.kanten arise. The wet paint is very fluid!
You are rewarded with truly amazing results.
With me there will be no more printed discs without the stuff!
Oh, to yield:
After around 15 machined discs makes the first box against a solid weight, an approximately to 1/4 to 1/3 emptied impression.
