---------------------------------
ATTENTION !!
There is a 603 / C1 and a 603 / C3 system here at Amazon. these are probably the two identical except for the connecting cable
the camera to fernauszulösen Camera. So if you want remotely trigger the following cameras:
// Copy of Description:
Compatibility: Canon EOS 600D, 60D, 550D, 500D, 450D, 400D, 350D, 300D, 1100D, 1000D Pentax K20D K200D K10D K100D Samsung GX-20 / GX-10
// Copy the end
should probably buy the 603 / C1 system. Otherwise, the cable does not fit.
Otherwise, what you have to "tinker" or additionally buy what.
---------------------------------
> Camera Shutter Remote Control !!
Here perhaps a tip for camera control (timer). In most cameras, it is not sufficient
the receiver being on the hot shoe. This triggers the camera mostly from not. To trigger the camera,
must by made receiver, the supplied cables are plugged into the jack on the camera, it works fine.
---------------------------------
> Who needs TTL:
... The 622C Yongnuos should watch which additionally support both TTL Fersteuerung of TTL capable flashes, as well as
looping (passthrough) of the TTL signal to a plugged-TTL enabled flash. However, they can not 602 or 603
System with trigger and vice versa. One would therefore form a cascade for example, to use the 622 system and the 603/602 system.
So camera on the 622 and on the 602/603. Then we headed (but probably looks like the Bremer Stadmusikanten :-) and unfortunately
then a possible still on top pinned TTL no longer a TTL signal, because the 603/602 in between depends.
I could imagine the following craze me but: the camera to 622C it pushed out the TTL flash system.
The 622C triggers a remote receiver from 622C to which in turn a 602/603 infected and this then triggers its 602/603
Recipients from :-)))) (as I said, only theory)