o Unfortunately, only a size of spacers (1)
o Completely exaggerated wall screws with hexagonal head (2)
o Wall rail for TVs will probably survive.
o The bands for releasing the locking hanging down the TV down (4)
- Miserable Instructions (3)
Conclusion:
Would I buy immediately!
(1) I have to connect my TV and Scart cable and acc. Jacks directly on the rear panel I needed but unfortunately 5cm distance (temporarily, until the corr. Devices are replaced). So I needed about 4cm distance. For this purpose I have the hardware store several washers (6mm), longer screws (5x6cm), nuts (6mm) and aluminum tube (8mm). Then I have four Alurohrstücke sawed, screwed with the nut and washers to the brackets and the whole then screwed into the TV. Keeps :-)
(2) So with these screws, six of them, you could certainly fix a gate on the wall - completely exaggerated. Especially when you consider that many TVs are then held with four 6mm screws. I have attached the wall channel with five bolts stronger. It is important to surfaces out here that you should not use any countersunk screws.
(3) Too small the whole. But self-explanatory. Unclear to me to this day, including the metal bracket is designed to one of the lower spacer.
(4) This can be easily circumvent natürlch. For example, you can shorten the straps so that they just hang up on the bottom edge of the TV. I have it hung just above on the bracket (behind the TV so), so my little one not rankommt there. One comes then but maybe not without tools to the tapes ran (esp. If you have used any spacers).
Additional info:
Consignor eSmart GmbH has sent turbo fast!