On the criticism concerning the processing of which is tuned. I bought these pliers New Today and in this are the blades, as mentioned in another review, about 0.5-1mm shifted over each other (perhaps intentionally so, so that there is no damage?). Unfortunately, the quality would sooner higher. I know an old Stripax from the 80s (identified by the "Made in W. Germany") and a Stripax 90 where the blades exactly superimposed and these pliers also isolate a little nicer from. The new Stripax it looks kind of choppy uneven. Today we have to produce smartphones equilateral schleißend with chips in the nanometer range, but tongs, which went into the 80s - no longer today ???? Furthermore, the almost continuous adjustment, not I like it, it was better before. There were 3 stages which you could remember and we did not have to push around forever until you had the setting. Handle the Stripax once not, then you just turned "into a higher gear." With this new "millimeter scale", it is a little fumbling, and the position is not to be reproduced for future recruitment. Last but not least, the main thing, there is a cutting protection to "unintentional cutting to avoid"! Yes! Had the cable cutter - so like 30 years has been usual - UP left on the forceps (always in view), then you would need absolutely no "cutting protection" for "unintentional cutting". Redesign to extol to any pseudo feature - comic approach. Oh, and the Teilabisolierfunktion - quite nice. One star deduction, because you can expect (in the stripping edges) for the price more accurate processing.