In value for money, the housing is really top. The integrated power supply (max. 200W), in energy-saving systems (my consumes 40W peak) are well operated without active fan, at least I have expanded it and the system has been running stable for quite a while. However, this conversion is not mandatory that his work carries the fan used very little noise. The case is well made and large, however, weaknesses show up on the HDD cage, no value was apparently placed on deburring, so you very quickly cuts on the sharp edges. Also, it is quite cumbersome to equip these (the framework takes both a 3.5 "drive, as well as the 5.25" drive on): a screw that needs to be solved at the front can only be achieved if the entire front panel decreases, this is associated with a certain force, since the clip fasteners hold very firmly. One always has this fear that a clip may break. From these two (minor) shortcomings resulted also the point deduction. The cable lengths inside are generous and so rich even in the farthest corner of a built-in motherboards. The housing is used by me for a mini-ITX board, which could be easily screwed. The housing acts for this Board size slightly oversized (30 cm x 40 cm x 9.5 cm), but you have to move so loads of space around the cord clean and hardly finds a smaller housing with 5.25 "drive bay. The 5.25 "drive bay is designed for a DVD drive and is therefore equipped with a spring-loaded front cover. If, like me, want to install a hard drive caddy, this is more of a hindrance. You can be expanded without any problems without violence, however. Only the button for the Open the drive is still in the way, a pity that this is not unscrewed so remained only the handle for Dremel. The package includes in addition to the power cord and massive screws also contain the mapped stand and 4 adhesive feet for a flat erection, also a small internal speaker, which can be glued inside.