FX-Clear:
+ Image quality is maintained
-unangenehmes String feeling on the screen (something rubbery)
-anfällig for fingerprints and grease stains
FX-Anti-reflective:
+ Very pleasant prank feeling. The surface is slightly rough, so you never stuck with your fingers (even with sweaty hands)
+ Significantly less prone to fingerprints
+ Reflections are significantly attenuated
-The Picture is (subjectively) a little darker and slightly crinkly. Me personally that has not bothered as the "ripple effect" is really only visible if you look at the display from 15 cm distance. And even then it is bearable.
I then decided it allow the antireflection. Overall, the phone feels just smooth, and you have not permanently remove fingerprints well. On the cell phone back then even eliminates the only drawback of antireflection, since one since has no display.
To assemble:
I realized that a clean attachment is trickier than I thought. The biggest problem is dust particles: one begins at the top Put the foil a dust particles, creating an air bubble. In general, occur when drauflegen ALWAYS bubbles, but these can be pushed out with the supplied plastic card or a credit card without problems aside. When air bubbles caused by dust that is not possible.
Therefore my urgent advice: to do in the installation manual must always be followed! Carry out the installation in the bathroom, and previously let out of the shower hot water until well much water vapor in the air floats (the air should be nice tropical feel;)). The moist air binds dust and eliminates static. Only then should start with the actual assembly (which is well described in the manual).
Even if in the manual one way is described how to remove a dust particle, this is almost impossible to carry out without capturing new dust grains. Believe me, you will save yourself a lot of trouble if you eliminated the dust vornerein. For me, I have achieved the desired result until the second attempt at the back, and the third attempt on the front. So it is good that a total of 3x2 films are supplied, as is a film first contaminated by dust, you can throw them away actually.
Things that have me still made a positive impression:
The foils have on both sides of protective films, which is withdrawn first during assembly. The upper protective film has a grid that helps you accurately plan Put the foil. So one need not to worry, to contaminate the actual film before mounting. All films tested were well tailored, ie no trouble with any non-matching camera recesses or similar. It is included pushing out a good microfiber cloth and a plastic card to the air bubbles. The manual is illustrated and detailed.
Conclusion: If you have the installation first behind him, this film is excellent - it looks classy and feels good.