Sharkoon USB3.0 Docking Station Combo Drive Link - IDE

Categories


  • PSU (unnecessary?) Huge and broken already on the 2nd day ... / otherwise good.  

    Sharkoon USB3.0 Docking Station Combo Drive Link - IDE / SATA to USB 3.0 (optional)
    The power supply overnight at the terminal strip "forgotten", but unit is not in operation - was extinguished forever the next time then a little audible "click" and the green LED on that component. otherwise - it was said, the actual
  • ... Connected and the same processes the hard disk  

    Sharkoon USB3.0 Docking Station Combo Drive Link - IDE / SATA to USB 3.0 (optional)
    ... Had anything to read through customer reviews, they were a great help, what you should consider. Then ordered the dock at Amazon. It was delivered to me in a flash. Have connected to the docking station all. In this case, once a SATA hard drive 5
  • Reuse old hard drives  

    Sharkoon USB3.0 Docking Station Combo Drive Link - IDE / SATA to USB 3.0 (optional)
    Top equipment at a low price could 3 of 4 IDE hard disk dinosaurs (was probably a really broken) as the data store Formatting or backup storage problems and continue using. Runs under Win7 prof. with me without complicated settings or driver stress.
  • Initial difficulties solved thanks Support  

    Sharkoon USB3.0 Docking Station Combo Drive Link - IDE / SATA to USB 3.0 (optional)
    At the beginning of the adapter has in general not work. The new SATA hard drive (Toshiba DT01ACA300 3000GB) was recognized in the Disk Management tool, but the formatting was not possible (error message), so I have first connected internally, where
  • Sharkoon USB3.0 Docking Station Combo Drive Link - IDE / SATA to USB 3.0 leaves no wish unfulfilled  

    Sharkoon USB3.0 Docking Station Combo Drive Link - IDE / SATA to USB 3.0 (optional)
    I've been looking for the possibility of an interface to connect IDE drives as an external hard drive to my system temporarily can. This makes the docking station without any problems. So it is possible, without internal connection to connect the pla
  • Practical adapter with weaknesses  

    Sharkoon USB3.0 Docking Station Combo Drive Link - IDE / SATA to USB 3.0 (optional)
    I bought this USB 3.0 docking station because it all possible ISE / [S] ATA disks with USB 3.0 can flexibly adapt to the computer. The installation is very simple. However, I think it's not so much that the SATA and 2.5 "IDE connector are located on
  • IDE and SATA to USB 3.0  

    Sharkoon USB3.0 Docking Station Combo Drive Link - IDE / SATA to USB 3.0 (optional)
    So far this Shark Room DriveLink Docking Station is the only station where Ide and Sata be connected with USB 3.0. I will look no further. Point. Runs perfect, recognize when they are jumpered properly, all the boards and is the identify of the plate
  • Road-Tested dock  

    Sharkoon USB3.0 Docking Station Combo Drive Link - IDE / SATA to USB 3.0 (optional)
    easy and effective dock. She read my oldest disks (1982). All hard drives can be used as additional drives. Highly recommended!
  • almost perfect - too short EIDE cable  

    Sharkoon USB3.0 Docking Station Combo Drive Link - IDE / SATA to USB 3.0 (optional)
    The Podukt came verpakt tidy. The tested disks (SATA + EIDE) were recognized and ran perfectly in the endurance test (8 hours full load). Neither power supply nor dock were hot. The data rates correspond to the possibilities of my USB3 interface. The
  • With a little taste !!  

    Sharkoon USB3.0 Docking Station Combo Drive Link - IDE / SATA to USB 3.0 (optional)
    Of course I've seen some information to me before buying. Here was always written again, the IDE drives were not recognized. With a little taste but I have this hammer out. Unfortunately, in this respect is unfortunately nothing in the instruction ma