The Raspberry located within the housing to a total of 6 bars (4 thickness at the corners and 2 thin in the area of micro-SD card).
One of the thicknesses lands must for the new Raspberry 2 milled down something or are cut off with a utility knife, as a SMD fuse on the bottom is further slid to the edge as the Raspberry B +. I have the bridge completely removed because the Raspberry is held at this edge or by the thin webs.
The recess for the CPU is also not suitable. Here you have the cutout in the housing slightly increase with a Dremel or craft knife if you have prior to placing a heatsink. I'm going to increase the cut-out and bring an extra for the GPU.
Since the case was not explicitly designed for the new Raspberry Pi 2, I can live with these minor flaws.