I raised the question, how do I connect a water tap in the bathroom with a Gardena hose. For those interested, via the tube is to be filled from the bathroom by a piece of the corridor, through the living room, on the balcony, the water tank of my one floor down in the parking lot standing motorhome. As a last resort I could use z. B. the shower hose connection, but would stay here everytime Unscrew the shower hose, screw on an appropriate adapter and need to assemble the whole thing again reversed after use. Then I accidentally discovered this adapter and ordered him at random and did not regret it a single time. This part is simply thought brilliantly and actually fits on all taps that have a bubble-use in normal size (only some have taps on the bath an oversized whirlpool-use), whether it is screwed or screwed into the faucet. All necessary parts are included, including the use of soda, which you (if it is eventually added lime) by a normal application (available through hardware stores) can replace when needed and even a new seal is. The installation is very simple, as long as you (also called water pump pliers) or a correspondingly large combination wrench has a pipe wrench or to manage otherwise know. It first removes the entire part of the bubble insert (ie with its holder). If the faucet has an external thread, you use the enclosed ring and screw it on the extent that this external thread is completely covered. Then you screw in the remaining internally threaded portion of the ring a bubble the extension holder with inserted bubble application using the rubber gasket and rotate it firmly as you tighten the nut of a shower hose. The installation at a Wassserhahn internally threaded (ie where the effervescent extension holder is screwed into the faucet) works the same way, except that you do not need the ring here. That was about it. For taps with male thread have to be possibly used to the sight, because of the metal part (ie the effervescent extension holder) of the adapter is a little longer and a little more massive acts as the original. For taps with internal thread the whole is hardly noticeable, since the tap is even wider. Now you can at any time the plastic adapter with slide open (black part is provided on the adapter) in place, and then close the slider (black part from the adapter off as in the picture). Now every hose fits with the Gardena-click part on this adapter. If you have previously carried out the installation properly and not forget the rubber gasket, molded as nothing next out, not even then, when the connected hose is kinked and thus the full water pressure acts on the adapter. I wonder, therefore, a little over a previous review. Here the adapter was either defective, what is more incredible or was something wrong in the assembly, which I suppose more. If the old seal and possibly lime residues removed at the tap and the new seal was used, the whole was dressed a little more than hand-tight and the sealing ring in aufzusetzenden plastic part available, and the slide was closed, it could actually be only leak if one the parts would have a plan and that would be seen. Perhaps the disposal was a bit hasty in the trash. I use some of Gardena actually very little, just this adapter and a Aufrollschlauch and am therefore no Gardena expert, but what I see from Gardena even with acquaintances, testifies generally of high quality. But this company is so well known.