The mill is well and very high quality.
At the first grinding process, the grinding stones have then also added and we had to expand this same clean and, apparently, the grains were still too much residual moisture. This must be taken in any case, and it is best to begin with a coarser grinding adjustment and then works its way to the desired freeness zoom, which you can even make during milling.
The machine also works quite quiet and does not move on the worktop and around.
So far so good, we wanted to grind coffee and have expanded the mill to change what is not as described, sometimes short of equip goes. Hopper screw down, remove the upper millstone and unscrew the screw on the lower millstone. Unfortunately, and this is the great weakness, you get the lower millstone out very difficult. Mostly I prefer the silicone insert upwards and try to pry the millstone, which certainly hurts the comb which is mounted below the millstone in the long run, but otherwise you just can not go there. If you've made it is only brushing times, from grinding preceded now everything must be cleaned. It remains quite a lot of flour on the side walls of the lower millstone and the bedeudet if one does not use the machine often, the best expand throughout the mill after each grinding and clean.
Grind the coffee has been shown that the mean adjustment brings the best results. However, the engine is running because it does not create the coffee beans between the millstones always idle, then it is switched off briefly and then back on. And in any case after cleaning the grinder, as slumbering ground coffee for good two cups of coffee. We therefore always the same grind 250g beans, to the cost of two cups of coffee in the morning is personally too high.
All in all, if you bring the time and leisure, but that's a great thing.
