Features:
Bandwidth: 40-862MHz
Gain: 20dB (the input signal is multiplied by 10 for the Max gain)
Adjustable gain: 0 ~ 10dB (the input signal is multiplied by 3 for the Low Gain)
Noise factor: deterioration of 6dB Signal / Noise
Input Impedance: 75 ohms
Output Impedance: 75 ohms
Max output: 85dBuV
Power supply: 220V / 50Hz
Dimensions: Length 15cm Width 8.5cm Height 3.7cm 7,85cm with connector (assembly plastic case is correct)
The 4 connectors "TV out" is the type: male TV coaxial 9,52mm diameter
The "Antenna Input" connector type: Coaxial TV socket diameter 9,52mm
You will need the 4 female TV blades and a diameter 9,52mm plug to connect to the housing.
The manual is in English (which is not very legal) and fit on an A4 sheet.
There is a difference between the advice on the case and those mentioned in the user manual about the adjustable gain.
On the case: 0 ~ 10dB Gain Control
On the manual: 0 ~ 12dB Gain Control
In operation the casing hardly heats. There is no on / off button.
I did not find any information on the power consumption of the device.
With the antenna amplifier are supplied two screws that I have not used.
Personally, I find this antenna amplifier, 4 channels, perfectly fulfills its task.
For the moment ... ;-)