Very delicate clicking at low torques | otherwise very good key with calibration certificate

Of the Rezenzionen that the key missing torque certified verunsichertet something, I still ordered the Wera-key, as it provides a huge torque scope at a reasonable price and I've had good experiences with Wera. Then the shock: The first use of the presumption, no torque function. Until I found that at very low torques
I would therefore someone who uses the tool mainly for torques in the field 1-5Nm, recommend a compact, specially designed for the little moments key as the torque wrench MicroClick MC 5 of Proxxon.

Since Wera Schlüsser can easily create its total length of 29cm a large torque, you have at the low torques - especially without previous experience with such an instrument - to be very careful. This is a disadvantage of per se should not be placed on the load tool, but can at inexperienced users cause frustration and damage to the thread.

Note must be that the torque wrench does have the length of a typical large ratchet 1/2-inch-recording, the recording but is only an a small 1/4-inch-recording here !! The greatest obtainable from Wera nut with 1/4 "drive is a 14-mm nut who wants to connect larger nuts, needs a very expensive adapter that there is practically only by STAHLWILLE. STAHLWILLE transition piece 1/4 inch to 1 / 2 Inch DIN 3123rd

Relieved now to the further experiences: The Wera-key has a unique large torque extent of 1-25 Nm with a very fine throughout the extent of division 0.1 Nm; the Scala even shows a line in the midterm Ritten - eg 0.15 -, but lock the key can 'only' every tenth-steps. But that is perfectly adequate and the setting works perfectly. The Verarbeiteung the key is very good, as you would expect from Vera.

Each torque wrench has on the side a serial number. and the key lies in a calibration certificate. This really is very good at this price! The certificate can be seen a table showing the measured and set torques at 5, 15 and 25 Nm. In addition to the test date and the name of the auditor stated in with it was a Mr / Ms sliding. The tests seem to be so carried out in Germany (where the torque wrench is manufactured, can not be said, because nowhere a "Made in ..." is). The measured tolerances lay with my keys at 1.3 to 2.5%, also very good values.

The key will be delivered in a black plastic box elongated, which is put together of two parts; for storage is necessary to use additional air cushion bag, otherwise it rattles in the box - I would have liked a 'nobler' case with such a high quality tool.

In sum up for the price (~ 85EUR, Stand 7/2014) very good tool! A comparable keys HAZET cost equal much more: Hazet 5108-2CT torque wrench 2.5-25 Nm, accuracy +/- 4% in a transparent box.

Who should still have a problem with the torque, can according to the, my previous Erfahlung, turn very generous customer and fast-responding customer service by Wera in Wuppertal.

Additional info:
Who needs a key only for Alu / Carbon wheel, which eventually reaches even the key of Proxxon with 3-15 Nm: Proxxon 23345 Torque wrench MC 15