In 2 of 9 I had in this long period of time each 1-2 "learning loss" that could be easily remedied by Steckerziehen and short Neuanlernen but.
I think - but it can not exactly belegen- the IR frequency on each Revolts operate, plays a decisive role ... Because even when Teach it worked with some frequencies better than others, man must therefore experimentiern einwenig ,
Update: 22/05/2013
Meanwhile, all 9 pieces of this 'Revolts' in use in my living room and all over the Harmony One controlled.
So you will only times aware ... how many standby eaters, ceiling lamps, LED lights ... accumulate over time as ...
I was recently six days away and both my 50 '' Panasonic plasma TV and the Onkyo AVR 3009 were thus complet de-energized, both devices have to keep your setup / configuration / channel list properly .. I had previously some concerns because a bunch work would have meant everything .. refurnish again ..
After a month of operation now 9 'Revolts':
- Not a malfunction / defect
- No learning loss
- At least 4 m distance = no problem
- Good response of the small IR receiver parts for all 9 with only an approximate aim for!
So continue to TIP-TOP :-), strong buy recommendation
A small minus but:
The Standby detection of 'Revolts' works (in my case) will not, presumably because several small and larger units run a Revolt IR can about each and the "rest-standby power" is too high?
Instead I turn via Harmony One then targeted the individual Revolt IR cans, so no problem bottom line.
- - - - - - - - - - - - - - - - - - - -
24.04.2013:
Somewhat hesitant in purchasing due to very different reviews, I have dared to order it is 3 pieces.
My concern in this case did not concern the Standby detection and shutdown but just the direct control over my Harmony One FB, I just did not want so many Funksteckdosen -FB on the sofa :-).
In the Harmony One online I have added a new (willürliches) device from the "Budget".
There I the three Revolt cans covered with the keys 1, 2 and 3.
As a source signal I have simply taken an old IR-FB that did not interfere with my current IR remote control, and can learn the signals to the IR learning mode of Harmony.
Pleasing in my eyes is that the 3 Revolt IR doses (unlike I mean to have read it) very well each have the same (!) Harmony button A as also turn OFF :-)
FB-distance up to 4 m has been tested without any problems (more is not needed for me). Approximate "top destinations" went smoothly.
One can only hope that the 3 "Revolts" in the long run the commands in the storage hold (except possibly at a power failure) and also work permanently .. (some had here probably unlucky?). Since about 2 weeks everything is running optimally only times!