For basic support:
It is in terms of its style, nothing negative to say.
The equipment rack is built very solid.
All necessary mounting screws, washers and spacers to accommodate various base units are (from M5 to M8 in different lengths)
Even the necessary screws and plugs for wall mounting (6 KNT woodscrews 8x80 and UX10 Fischer anchors) were there.
The hinges can be very good move, easy but again not so easily the "run away" the display (if you have the basic carrier is not 100% assembled in solder or mount could)
The main articulated arm allows a horizontal swivel range of 180 ° the device support, depending on the position of the main articulated arm also can be turned horizontal again. This can here depend on the screen size and position the main arm and 180 °. The total swivel range but will never be greater than 180 degrees.
A Vertical rotation is not possible, it can only tilt the display in a very restricted area, with set screw, set, this range can be extended by the appended spacers.
The (fast) recording system is easy to handle, the display (or TV) can be set up easily and also lose weight again, it sits after snapping also fixed on the carrier.
The only negative (for me at my TFT TV) is the massive and extremely long (89 cm) equipment rack of horizontal speed recording.
What I did not think that is, that is the communication interface (Scart, S-Video, LAN, optical audio, electric, audio, antenna and satellite) are exactly on my TV at half the unit height on the left rear side. These are, even with mounting bracket with the supplied spacers so covered that they are no longer accessible.
Only the side exiles USB and HDMI ports, as well as the CI slot are to be achieved.
Who now a external receiver USER and the TV with an HDMI cable connects and its DVD player connects via HDMI side has no problems.
But who wants to use the internal Thuner, Smart TV (via Web / LAN), audio equipment, video camera, game console or video projector via the above interfaces has a problem, he is no longer ran there.
I have solved the problem that I have shortened the device support on the left and have a new stop (Fall Protection) attached. Can or will not make any.
That reminds me of the holder otherwise like very much, but to me a notice may lack the connections are no longer accessible, he only gets 4 stars.
I actually believe not the one with a holder for monitors up 50Zoll a device support 50 cm longer need (but eh have almost all VESA 400 mounts).
Have taken the test and in a G ... G ... market demand because they told me I could use the holder for my TV without restriction, he said holder also ha ha :) (the seller). There, the holder was actually 25% more expensive.