Everything you need for this is a
Mirror
a cup of cold water
a cup of boiling water
a spoon
a cup where about 1 tablespoon of olive oil for the finger nails + reinpasst
a nail file
a nail scissors
possibly even superglue
First stop the canines. If your gums have to touch this, the edges are filed down until it your gums no longer touch. This is very important so you do not drill into your gums and the gums are sore else!
After you have filed your teeth from tried different positions. It was important to be able to bite the teeth together afterwards. Should sit Think about how the catch afterwards. If you've found your positions and margins not hit your gums above water must be boiled in the kettle or on the stove until it bubbles right.
Pour the boiling water into a cup. Now it has to go quickly, otherwise the thermoplastic spheres are no longer hot enough!
Immerse your fingertips in the oil and rubbed the oil on your fingertips and nails, so that the mass does not stick to it.
Addiction you now want to start the tooth with the her.
I have used about 20 per tooth beads. But give your beads onto a spoon and dipped it carefully into the freshly brewed water, so that all beads covered with the hot water can not fall off the spoon. After a short time the beads are transparent and adhere to each other. Now is the right time to bring to the spoon from the hot water and the mass to form in a lump and push in your DRY tooth and put it over your canine. Aligns the tooth now swiftly to the position of the Do you want to have. Expresses the supernatant mass on the teeth and gums, front and rear. If you have to have all pressed well wait you 2 minutes.
I immediately after use, the teeth a few times bitten together. Will not all the time to keep your mouth open later.
After these 2 minutes brings her carefully the canine out of your mouth and puts it in a cup of cold water. If the ground is hard and really knows, so you can take them out of the water.
Now you take a few beads back and modeled your other teeth as described above. Thus, the catches have even consistency I have the first left after curing in the mouth and the Second properly aligned. After both were finished I asked them for an hour in the cold cup.
The good thing is, you can at any time the plastic already used again melt in hot water and use it again.
With my teeth I have front cut the supernatant thermoplastic careful with the nail scissors. Rear I have so that they keep everything so calmly better. Should it somewhere then press it just comes off.
On the internet I have read several times that may fall off from the plastic teeth before. With super glue you can glue the tooth back to the plastic. The whole thing can be very good but air dry.
Hope I could help all.