Weak points:
- No documentation. It is unclear which mode put the IDE disk (master or slave). Mine works in master.
There is a SATA connector for each direction, and the direction is written in small print next to each connector
- Bad IDE connector: IDE connector is the right size. Being slightly smaller, it is possible to connect it by shifting the pines. Even the actuator is sufficiently small not to do its job. I almost revoyer mine that did not work before I make me that he was shifted.
- There are residues of paste solder in the solder connectors, which does not instire confidence.
I have not tested the performance. compared to a pure IDE.