After 12 years, I wanted to send my old All-sucker from Kärcher to retire. He still works properly, but he fights difficult with some leaks that suck him. Simple tastes as I have in tool - Nothing but the best - I have here resorted back to top device in the consumer realm heritage. What can I say, its suction power is top, the filter cleaning easier than the old predecessor, the blower function is also an added value and also the connection of electrical devices with a direct circuit of the vacuum cleaner depending on the operating state of the jigsaw for example, is very good. What, however, very disappointed me with respect to the top of the consumer market empire, the fact is that is not automatically rolled up the cord as in conventional vacuum cleaners in the house by pressing a key in the housing. We must roll up it by hand and stowed on a hook. This can be seen, of course, on the product photos never sugarcoated !! There is no cable to see .... So I walked away from that is the retract function also available here. Unfortunately not .... He is not stowed so tidy and the cable always hangs around outside. Also disappointing is the somewhat cheap-looking floor nozzle. You may well be robust for the rough work use, but I would also expect here a nozzle where the head can be folded down in the appropriate angle. Here, the angle is fixed and can not be changed. As a result, the wheel is elevated when vacuuming distant dirt particles through the long laying out the suction tube of the nozzle head. That sounds a bit bumpy formulated ... But I'll describe it again with the sucker in the house: If I want to suck something flat under the cabinet here, works from the floor nozzle, even when the suction is completely flat on the ground. The nozzle can here you do not. You would show in the solid angle. So there is still potential for improvement. I have helped me here with a cheap floor nozzle for conventional vacuum cleaner. However, he fulfilled perfectly Its main function.