I have the charger now 2 days in (permanent) use and have to say that the zugesichrten properties work well so far (as opposed to Maha / Powerex MH-C9000). Loading, unloading and the test / refresh programs run properly, it will all batteries found free of errors and treated as required the settings.
In the following points, however, I see room for improvement, especially when you compare the device with similarly expensive or even cheaper chargers from model range:
- Acoustic signal when a program (loading, unloading, Check, Cycle) has been completed is missing
- If the shaft A and B (9V blocks) are not used, the lines should be used in the display for additional information on Tray 1 to 4 (mAh, voltage / load current).
- (. Possibly with names setting, otherwise only with Prg 01-10) storing programs with the set values
What is missing in any case, is an 8, 12 and / or 16 port version, since it's so far not in reasonable quality with display are (Ansman 16 has no display + no settings vornehmbar, Tensai qualitatively questionable and a charging current of 500mA is not just up to date, I would like to 8x Powerex after the experience with the MH-C9000 does not even try also has the 800 500 and 1000 mA and 808 1000 and 2000 mA charge current so getting a few settings are missing)
I would prefer my model chargers use (15-30 cells are there no problem) However, you can switch the cells there only in number and equalizer for NiMH there is not, unfortunately, so you can use only the formation charging current to play it safe to go and no cells are destroyed, they take then but always 12-16 h and it can only cells of the same capacity and the same charge level as possible are used. So this is not a viable solution.
Should anyone still have a tip for an appropriate charger, just tell me.
So, enough moaning ... I hope it helps some of their decisions on ....
