The pressure hose from the pump to the multi-way valve is the only one of the hose clamps were there. This is also so in the parts list, so do not forget yet mitzubestellen half a dozen with the hose: 2 * inlet hose, 2 * outlet hose, 1 * drain hose, and an extra, because I always whatnot. :-)
I also recommend slightly grease all connections with Vaseline or faucet grease. Hose approaches are easily sealed and can slide better on tight sleeves; Thread with a rubber seal (. Eg the cover of two ports for UV disinfection, etc.) include lighter and conserve rubber; and also the large ring seal between the filter housing and its lid stays supple and seals longer if you can bestow her a little greasy love.
Teflon tape was completely unnecessary, except when screwed gauge that dripped sooo slow. The Teflon tape was wrapped at the factory not to the threads, but on the neck ... repair time: ten seconds now everything fits.
The pump is wonderfully quiet! The * old * pump was designed for 6 m³ per hour (without a filter, only the circulation mode) and had a been proposed journal bearing; the new I hear not practical, and it pumps (also with filters in the circuit), that the dirt in the pool of hearing and sight.
Incidentally, the cheapest is the blue hose from Elecsa (20 for 10 m), 38 mm in diameter (1 "inch), separable every 50 cm. Fit is tight, work.
The other parts that I have used are:
Filter sand: silica sand for sand filter systems 25 kg grain from 0.4 to 0.8 mm
Hose clamps: Sanifri 470010476 hose clips (W1) bandwidth 9 mm DIN 3017, clamping range 35 - 50mm, 10-Set
Tube: (1,99EUR / m) pool hose Swimming pond 10m hose model ELECSA 9410
Skimmer and inlet nozzle I have maintained from the previous installation, which saved me the Poolentleeren. The tube work I have replaced, because the old one only 32 mm in diameter, ie 1 'inches, had (the more the better! :-)), And because it had stress fractures. Today, anyway everything except the Intex 32/38 mm combi terminal.